Installation Guide
Installation
1
INSTALLING THE HANGING BRACKETS
NOTE: Before installing, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Attach the hanging brackets (AA) to the back of
the mirror using the included screws (BB).
AA
BB
2
INSTALLING THE HANGING WIRE
NOTE: This step is optional, and the
hanging hardware is not included.
□ If you choose to use hanging wire (not included), a
steel wire with a minimum weight rating of 75 lbs. is
recommended. Attach it to brackets as shown below.
TOOLS REQUIRED
Claw hammer Safety goggles Phillips screwdriver Power drill
Measuring tape Wall hardware Level
HARDWARE INCLUDED
AA - Hanging bracket
x 2
BB - Screw
x 4
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-888-774-8062 for further assistance.
Item#
1000 003 011, 1000 013 634,
1000 019 054, 1000 398 665,
1000 398 655, 1000 398 646,
1001 572 031, 1001 319 442,
1002 844 079, 1002 844 081,
Model#
M2430-JVM, M2430-ACO, M1925-JVO,
MS2431-GOK, MS2431-WHT, MS2431-SVL,
MS2431-TRF, MD2532-CRM, M2935-WHT,
M2935-DV,
Use and Care Guide
Mirror
3
INSTALLING THE MIRROR
□ For wall stud installation, insert #12 x 3 in. screws with washers into the
stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations and insert
toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the appropriate locations
and insert #12 wall anchors, followed by #12 x 3 in. screws (not included).
□ Once the mounting hardware is installed, hang the mirror from the
hardware using the hanging brackets or the hanging wire (not included).