Instructions / Assembly
2
Table of Contents
Safety Information .................................2
Warranty .................................................2
Pre-Installation ......................................3
Pre-Installation Inspection ......................... 3
Installation Location ................................... 3
Specifications ............................................ 3
Dimensions ................................................ 4
Tools Required ........................................... 4
Package Contents ...................................... 4
Installation ............................................. 5
Filter Cartridges .................................... 6
Filter Cartridge Life .................................... 6
Filter Cartridge Replacement ..................... 6
Troubleshooting .................................... 6
Safety Information
Read all instructions before installing and using your
water filtration system. Follow all steps exactly to
correctly install. Reading this manual will also help
you to get all the benefits from the filtration system.
This system has been tested according to NSF/ANSI
Standard 42 and 53 for the specific performance
claims as verified and substantiated by test data.
The rated capacity for this system is 750 gallons
(2839 liters) at a rated service flow of 0.5 gallons
per minute (1.9 liters per minute).
All plumbing must be completed in accordance with
national, state and local plumbing codes. Local code
information can be obtained at your local public
works department. In Massachusetts, plumbing
code 248 CMR 3.00 and 10.00 shall be adhered to.
Consult with your licensed plumber.
WARNING:
: :
: Do not use with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system. This system is certified for cyst reduction
and may be used on disinfected waters that may
contain filterable cysts.
CAUTION:
: :
: Do not install the filtration system
outside, or in extreme hot or cold temperatures.
Temperature of the water supply to the filtration
system must be between 40°F and 100°F. Do not
install on a hot water line.
NOTICE:
: :
: This filtration system works on water pressures of 30
psi (minimum) to 100 psi (maximum). If your house water
pressure is over the maximum, install a pressure reducing valve
in the water supply pipe to the filtration system.
NOTICE:
: :
: All plumbing codes must be completed in
accordance with national, state, and local plumbing codes. Local
code information can be obtained at your local public works
department.
NOTICE:
: :
: In the state of Massachusetts: The Commonwealth
of Massachusetts plumbing code 248-CMR shall be adhered to.
A licensed plumber shall be used for this installation.
Warranty
GLACIER BAY WATER FI
GLACIER BAY WATER FIGLACIER BAY WATER FI
GLACIER BAY WATER FILTRATION SYSTEMS
LTRATION SYSTEMS LTRATION SYSTEMS
LTRATION SYSTEMS -
--
-
WARRANTY
WARRANTYWARRANTY
WARRANTY
Glacier Bay Water Filtration Systems are manufactured under the highest standards of quality and workmanship.
Glacier Bay Water Filtration Systems warrants to the original purchaser that this system will be leak and drip free
during normal domestic use for a period of one (1) year from date of purchase. If this system should ever develop a
leak or drip Glacier Bay Water Filtration Systems will free of charge provide the parts necessary to put the system
back in good working condition. A replacement for any defective part will be supplied free of charge for installation
by the purchaser. Defects or damage caused by use of other than authorized parts are not covered by this warranty.
This warranty shall be effective from date of purchase as shown on purchaser’s receipt. Glacier Bay Water Filtration
Systems shall be installed per the manufacturer’s installation instructions and specifications. Some states do not
allow limitations on how long a warranty lasts, so the above limitation may not apply to you. This warranty is valid
for the original purchaser only and excludes industrial, commercial, or business use of the product, product misuse,
and product damage due to installation error, whether performed by a contractor, service company, or yourself.
Glacier Bay Water Filtration Systems will not be responsible for labor charges or for damage incurred during
installation, repair or replacement, nor for incidental or consequential damages. Some states, provinces and nations
do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusions or
limitations may not apply to you. Glacier Bay Water Filtration Systems will advise you of the procedure to follow in
making warranty claims.