Installation Guide

Installation
1
3
Finishing the installation
□
Turn on the water supply, check for leaks, and
tighten as needed.
Preparing for installation
□
Remove the existing showerhead, shower
arm (counterclockwise) and flange with a
wrench.
4
A
2
Installing the showerhead
□
Apply the thread sealant tape to the shower arm .
Hand-tighten the showerhead (A) (clockwise) onto
the shower arm .
□
Care and Cleaning
□
□
□ Do not use abrasive cleaners when cleaning this showerhead.
Preserve the finish of the showerhead using a non-abrasive wax.
When using non-abrasive cleaners, rinse off immediately when finished cleaning the showerhead.