Installation Guide

10
Problem Possible Cause Solution
There are leaks from the
handle.
□
The bonnet nut is loose.
□
The O-ring on the cartridge is
dirty or damaged.
□
Tighten the bonnet nut.
□
Clean or replace the O-ring.
The aerator leaks or has a
reduced water ow.
□
The aerator is dirty or mis-tted.
□
The cartridge may be clogged.
□
Remove the aerator and check for
debris.
□
Remove cartridge and check for
debris.
□
Ensure the aerator is properly
installed.
The sink drain at the base of
the sink is leaking.
□
The sink surface is rough or
irregular.
□
Apply additional silicone sealant to
the beveled side of the drain ange.
□
Apply silicone sealant to the beveled
side of the rubber washer on the
drain body.
□
Retighten and test for leaks.
The water will not shut off
completely.
□
The cartridge bonnet nut
is loose or cartridge is not
positioned correctly.
□
The cartridge is damaged.
□
Reinstall the cartridge after cleaning
and tighten the bonnet nut.Tighten
lock nut.
□
If problem still exist, replace the
cartridge.
□ To clean, wipe down with a damp cloth and towel dry.
□ Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
Care and Cleaning
NOTE: Refer to the service parts section in this manual for a
detailed drawing showing the location of the parts listed below.