Installation Guide

4
Shut off the water supply.
Insert the faucet assembly (J) through the hole in the sink.
5
Securing the faucet assembly Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Topmount Installation (continued)
9
J
21
Sink
Push
up
21
1 1
Push
up
21
2
3
3
Sink
21
Sink
Continue to push up
and turn clockwise
to tighten
From underneath the sink, secure the faucet assembly
to the sink with the FastmountTM system (21). Push
the FastmountTM system (21) up over the threads until
it stops against the bottom of the sink, then hand turn
(clockwise) to tighten.
Attaching the quick connector
to the receiving block
6 7
9
18
Weight
here
Weight
here
20
20
19
19
Installing the weight
Install the weight clip (20) at the point of the hose marking
"weight here”.
Insert the weight (19) onto the clip (20) by sliding it down
onto the clip (20).
Push the quick connector (18) firmly upward and attach it
to the receiving block (9). Pull down moderately to ensure
the connection has been made.