Installation Guide

11
Removing the quick connector Installing the grid
If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and then
pull down to disconnect.
Pull
down
Squeeze
1
1
2
Topmount
12
11
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
1
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
J
H
D
E
G
F
When finished, place the sink grid (G), cutting board (D),
basket (E), rolling grid (F) and strainer cover (H) into the sink.