Installation Guide

7
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
B
A
1
Installation (continued)
Operation
7
Checking the operation of the
pop up
9
Flushing and checking for leaks
2
3
1
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
□ Operate the lift rod (M) up and down to verify
that the stopper (D) opens and closes correctly.
□ Use 1/2 in. I.P.S. faucet connections (1), or a
3/8 in. O.D. ball-nose riser (2) with supply line
coupling nuts (3) (not included).
□ Use a wrench to tighten the connections. Do not
over tighten or torque the copper supply line.
□ Ensuring the handles are in the off position, turn
on the water supply and check for leaks. If you
discover any leaks, check your connections to
ensure they are installed properly.
□ Use a coin to remove the aerator (B) from the
faucet (A). Lift the handle to allow the water to
run for at least one minute. This flushes away any
debris that could cause damage to internal parts.
□ Turn off the water and reinstall the aerator (B) and
housing (if applicable).
8
Making the water supply
connections
D
M