Installation Guide

5
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
1
3
Insert 2
Insert 1
2
J
I
J
I
2
1
H
D
H
1
2
SILI
F
1
G
E
H
3
Installing the drain body
4
Installing the stopper and
horizontal rod
□ Apply silicone sealant (not included) under the
drain flange (E) and place the drain flange (E)
over the drain hole in the sink.
□ From underneath the sink, screw the drain body
(H) onto the drain flange (E). Ensure that the
opening (1) for the ball rod on the drain body (H)
faces towards the rear of the sink.
□ Tighten the rubber washer (F) and lock nut (G)
on the drain body (H). Do not overtighten.
□ Before installation, unscrew the protective cap
(1) from the horizontal rod (J).
□ Insert the stopper (D) into the drain hole in the
sink.
□ Insert the horizontal rod (J) into the drain body
(H) and through the hole of the stopper (D). See
insert 1.
□ For easier removal and cleaning, rotate the
stopper (D) 90 degrees so that the horizontal
rod (J) does not go through the hole in the
stopper (D). See insert 2.
□ Make sure the joint (I) on the horizontal rod (J)
inserts into the drain body (H) completely, as
shown (2). You can press the two sides of the
joint (I) to remove the horizontal rod (J).