Installation Guide

Installation (continued)

Installing the lift rod

□ Slide the lift rod (S) down into the lift rod strap

(Q) through the faucet (A) until it clicks into the

lift rod strap (Q).

Installing the stopper and

horizontal rod

□ Insert the stopper (J) into the drain hole in the

sink.

□ Before installation, unscrew the protective

cap (1) from the horizontal rod (P).

□ Insert the horizontal rod (P) into the drain body

(N) and through the hole of the stopper (J) until

you hear a click. See insert 2. You can press the

two sides of the joint (O) to remove the horizontal

rod (P).

NOTE: For easier removal and cleaning, rotate the stopper

(J) 90 degrees so that the horizontal rod (P) does not go

through the hole in the stopper (J). See insert 3.

NOTE: If a shorter lift rod (S) is required for your

installation, you may call Glacier Bay Customer service

for assistance.

Insert 3

Insert 2