Model #F2116 STAINLESS STEEL PULL-DOWN KITCHEN FAUCET
Important Information................................2 Warranty...............................................2 Pre-Installation .......................................2 Planning installation.................................2 Tools and Hardware Required.......................2 Part List ……..........…….........................3 Installation ...................................... ....4 Care and Cleaning ...................................9 Troubleshooting.... .................................
Pre-Installation (continued) PART LIST A R S T B C D E Q F M G H I P J K O L Part Description Quantity Part N Description Quantity A Faucet Assembly 1 K Hose Protector 1 B Cartridge 1 L Mounting Shank 1 C Screw Nut 1 M Escutchen 1 D O-ring 1 N Waterproof Foam 1 E Cap 1 O Tool 1 F Handle 1 P Weight 1 G O-ring 1 Q Pull-out Hose 1 H Rubber Washer 1 R Supply Hose 2 I Metal Washer 1 S Outlet Hose 1 J Fixing Nut 1 T Spray Head 1
Installation 1 Preparing for installation CAUTION: Always shut off the water supply before removing or replacing any part of a faucet. Open the handle to relieve water pressure and ensure that the water is completely shut off. □ Remove the weight (P). □ Remove the protective clip (1) on outlet hose (S). Push the tab (2) of outlet hose (S) upward and then pull down the quick connector (3) of pull-out hose (Q) to disconnect them.
Installation (continued) 4 Securing the faucet assembly □ Pull out the hose (Q) slowly to recommended position where the quick connector (3) stay right out of the mounting shank (G). DO NOT pull out the hose (Q) completely from the faucet (A). □ Install the rubber washer (H), and metal washer (I) onto the threaded mounting shank (L). □ Thread the fixing nut (J) onto the mounting shank (L). Lock it into position by tightening with the provided tool (O) and Philips screwdriver. Do not overtighten.
Installation (continued) 5 Installing the weight □ Push the pull out hose (Q) back inside the faucet (A). □ Install the hose protector (K) onto the mounting shank. □ Install the weight (P) at the point of the hose marking “Weight Here”.
Installation (continued) 6 Attaching the quick connector to the receiving block □ Push the quick connector of pull-out hose (Q) firmly upward and attach it to the receiving block of outlet hose (S). Push until a “Click” is heard. Tug downward to test engagement. □ Attach the protective clip on the outlet hose (S).
Installation (continued) 7 Making the water supply connections CAUTION: The hot and cold inlet tubes are indicated by their colors: red means hot and blue means cold. Avoid twisting wires together or placing the wires close to each other and damaging. □Thread the nut on the supply hose (R) onto the outlet of the water supply valve and tighten with a wrench. Do not overtighten. 8 Install the spray head □ Install the spray head (T) onto the pull-out hose (Q).
□ □ Problem Possible Cause Possible Cause There are leaks underneath the handle. The screw nut has come loose and the o-ring on the cartridge is dirty or damaged. Tighten the screw nut. Clean or replace the cartridge or o-ring. The aerator leaks or has an inconsistent water flow pattern. The aerator is dirty or misfitted. Remove the aerator and check for debris in the aerator screens. The cartridge may be clogged. Remove the cartridge and check for debris. Ensure the aerator is properly installed.
