Model #F2127 STAINLESS STEEL PULL-DOWN KITCHEN FAUCET
7 7 □ Observe all local plumbing and building codes. □ Cover the sink drain to avoid losing any parts. □ Review all the warnings, care, and maintenance information. LIMITED LIFETIME WARRANTY Glacier Bay products are manufactured with superior quality standards and workmanship and are backed by our limited lifetime warranty. Glacier Bay products are warranted to the original consumer purchaser to be free of defects in materials or workmanship.
Pre-Installation PART LIST N O Quantity Part Description Quantity Part A Faucet Assembly 1 I Weight 1 B O-ring 1 J Pull-out Hose 1 C Rubber Washer 1 K Water Supply Hose 2 D Metal Washer 1 L Outlet Hose 1 E Fixing Nut 1 M Sprayer 1 F Hose Protector 1 N Escutchen 1 G Mounting Shank 1 O Waterproof Foam 1 H Tool 1 Description
Installation 1 Preparing for installation CAUTION: Always shut off the water supply before removing or replacing any part of a faucet. Open the handle to relieve water pressure and ensure that the water is completely shut off. □ Remove the weight (I). □ Remove the protective clip (1) on outlet hose (L). Push the tab (2) of outlet hose (L) upward and then pull down the quick connector (3) of pull-out hose (J) to disconnect them.
Installation (continued) 3 4 Securing the faucet assembly □ Pull out the hose (J) slowly to recommended position Installing the weight □ Push the pull out hose (J) back inside the faucet (A). □ Install the hose protector (F) onto the mounting shank. □ Install the weight (I) at the point of the hose marking “Weight Here”. where the quick connector (3) stay right out of the mounting shank (G). DO NOT pull out the hose (Q) completely from the faucet (A).
Installation (continued) 5 Attaching the quick connector to the receiving block □ Push the quick connector of pull-out hose (J) firmly upward and attach it to the receiving block of outlet hose (L). Push until a “Click” is heard. Tug downward to test engagement. □ Attach the protective clip on the outlet hose (L) for security. Protective Clip 6 Making the water supply connections CAUTION: The hot and cold inlet tubes are indicated by their colors: red means hot and blue means cold.
□ □ Problem Possible Cause Possible Cause There are leaks underneath the handle. The screw nut has come loose and the o-ring on the cartridge is dirty or damaged. Tighten the screw nut. Clean or replace the cartridge or o-ring. The aerator leaks or has an inconsistent water flow pattern. The aerator is dirty or misfitted. Remove the aerator and check for debris in the aerator screens. The cartridge may be clogged. Remove the cartridge and check for debris. Ensure the aerator is properly installed.
