Installation Guide
8
[Heading goes here]
Care and Cleaning
□ Cleaning with a dry cloth may be sufcient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
7
Mounting the unit to the wall
NOTE: For safety reasons, it is imperative that this unit
be mounted to the wall.
NOTE: Before cutting, drilling or hammering into any wall
surface, verify the location of electrical, plumbing and gas
lines. Cutting any of these may cause serious injury.
□ Make sure the assembly is level. If not, adjust the feet (DD)
as needed.
□ Mark mounting points on the wall through the holes in
the rear tubes of the unit.
□ Hammer wall anchors (FF) into the wall, unless the mounting
screws (EE) will go directly into a stud.
□ Place the unit against the wall, lining up the wall
anchors (FF) and holes in the rear tubes.
□ Tighten the mounting screws (EE) into studs or wall
anchors (FF).
FF
EE
Installation (continued)