Installation Guide

9 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
[Heading goes here]
Installation (continued)
9
Mounting the unit to the wall
□ Mark the mounting points on the wall through the holes in
the rear tubes of the unit.
□ Hammer wall anchors (FF) into the wall, unless the mounting
screws (EE) will go directly into a stud.
□ Place the unit against the wall, lining up the wall
anchors (FF) and the holes in the rear tubes.
□ Tighten the mounting screws (EE) into studs or wall
anchors (FF).
NOTE: For safety reasons, it is imperative that this unit
be mounted to the wall.
NOTE: Before cutting, drilling or hammering into any wall
surface, verify the location of electrical, plumbing and gas
lines. Cutting any of these may cause serious injury.
EE
FF
Care and Cleaning
□ Cleaning with a dry cloth may be sufcient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.