Product Specs

TM20-B/QQ
GL solutions Inc. JAPAN
separate from production firmware. Host integrators should contact GL Solutions
Inc. for assistance with test modes needed for module/host compliance test
requirements.
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the end
product which integrates this module. The end user manual shall include all
required regulatory information/warming as shown in User manual.
In the end product, the antenna(s) used with this transmitter must not be co-
located or operation in conjunction with any other antenna or transmitter except
in accordance with FCC multi-transmitter product procedures. User and installers
must be provided with antenna installation instructions and transmitter operating
conditions for satisfying the RF exposure compliance.
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) this device may not cause harmful interference and
2) this device must accept any interference received, including interference that may
cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. For body worn operation, this device has been tested and meets FCC RF exposure
guidelines. When used with an accessory that contains metal may not ensure
compliance with FCC RF exposure guidelines.
ISED
Canadian Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.