Manualshelf

User Manual

ManualsBrandsGL.iNet ManualsComputers & AccessoriesGL-S1300 (Convexa-S) Home AC Gigabit VPN Router, 400Mbps(2.4G)+867Mbps(5G) High Speed, DDR3L 512MB Flash ROM, 8GB EMMC, OpenWrt Pre-Installed, Wi-Fi Networking
11121314151617181920
Page 14 | 150
4G
Yes
GL.iNet/steven
Host-less
4G
Yes
GL.iNet/steven
QMI
4G
Yes
Host-less
*QMI: This modem supports QMI mode. Please choose /dev/cdc-wdm0 in the Device
list.
*Host-less: This modem supports tethering mode, please set up by using Tethering but
not 3G/4G modem.
You can also refer to http://ofmodemsandmen.com/supported.html for a well-supported
modem list.
2.4. Tethering
Using USB cable to share network from your smartphone to the router is called
Tethering. Host-less modem works in Tethering during the setup of the modem as well.
For host-less modem tethering, plug it into the USB port of the router.
For smartphone tethering, connect it to the USB port of the router and click Trust to
continue when the message pops up in your smartphone.
After plugging in your device, the Tethering section will update and your device will be
shown on the device list. The device name will begin with eth or usb such as eth2, usb0.
Choose your device and click Connect.
3. WIRELESS
In WIRELESS, you can check the current status and change the settings of the wireless
network created by the router. The wireless network can be turned on or off by switching
the ON/OFF button.