Manualshelf

User Manual

ManualsBrandsGL.iNet ManualsComputers & AccessoriesGL-S1300 (Convexa-S) Home AC Gigabit VPN Router, 400Mbps(2.4G)+867Mbps(5G) High Speed, DDR3L 512MB Flash ROM, 8GB EMMC, OpenWrt Pre-Installed, Wi-Fi Networking
121122123124125126127128129130
Page 122 | 150
Reset
1. When you press down the reset button, the middle LED will start to flash once per
second. Release your finger if the LED just flashed once (1 seconds), the Tor will try
to change a new Exit node.
2. If you keep the button pressed for 3 seconds, it will flash quicker, twice per second.
Now release your finger your network will reset, including disable repeater, set lanip
back to 192.168.8.1 and enable dhcp. Use this function if your repeater cannot
connect which causes your wifi down
3. When you keep holding the reset button for 8 seconds, the middle LED will start to
flash even quicker, 4 times per seconds. Release your finger now, your firmware will
revert to factory status and reboot.
Switch
1. Left side: You will be connected to Tor network. You cannot access the admin UI.
2. Rigth side: Normal Internet. You will be able to access the admin UI.
9. MORE SETTINGS
9.1. Admin Password
Change the password of the web Admin Panel, which must be at least 5 characters long.
You have to input your current password in order to change it.