Instructions / Assembly

205

Mark the position of the

screw hole on the wall,

drill and install the water

inlet body.

cold water

hot water

Interior wall

PS:In the process of embedding the wall,

please do not remove the protective sleeve to avoid damaging the copper sleeve.

Please read the instructions before installation

sealant

Allen key

slotted screwdriver

Phillips screwdriver

The interior wall is flush with the main plane

Ceramic tile surface

1. After unpacking, check whether the product is in

good condition. The tools required for installation

are not supplied with the goods. Please bring

them yourself;

2.The instructions contain precautions, please

keep them properly;

3.The dimension drawing of the manual is only for

reference, please take the real object as the

standard.

1.The sundries at the connection must be removed

before installation to avoid blockage or water

leakage.

2.Correctly connect the tap water inlet (hot on

the left and cold on the right)

3.The maximum temperature of hot water shall not

be higher than 80

After the main body is embedded in the wall, install it in the following order:

1.Remove the protective sleeve;

2.Cover the panel;

(mm)

(120mm)

1.92"

(49mm)

(205mm)

2-G1/2

205

3.Install the handle and water outlet connector.