User's Manual

Given Imaging Ltd.
DOC-0062-02 9
M2A Patency Scanner Operation
When not in use, the Scanner is stored hanging on a hook installed in your office.
For further information, refer to Specifications on page 14.
To turn on the Scanner, press the ON button. A self-test mechanism checks the
functionality of the Scanner. The Power ON LED indicates that the Scanner is
ready for use. The Scanner is ON for 30 seconds, during which it transmits and
receives signals. The Scanner turns off automatically after 30 seconds, unless you
press the button again, in which case a new cycle of 30 seconds begins.
In case you turn the Scanner on and its self-test mechanism detects a malfunction,
the Power ON LED blinks in red for a few seconds and the Scanner automatically
turns off. If the batteries are low, the Battery LED blinks shortly and the Scanner
automatically turns off. In this case, change the batteries as described on page 23.
Attach the TesTag to the indicated spot and press the ON button again. If the
Scanner beeps, the environment is appropriate for the Scanner’s operation and you
can proceed using it in this environment. If the Scanner does not beep, repeat the
test at a different location, until you find a location that does not interfere with the
proper functioning of the Scanner. Alternatively, you can turn off all monitors
within a 5 meters radius.
This test must be performed each time before using the Scanner to detect the
presence of an M2A Patency Capsule.
For specifications and technical parameters of the M2A Patency Scanner, refer to
Specifications on page 15.