User Manual
Table Of Contents
- Book 1: Setup & Maintenance
- Table of Contents
- Chapter 1
- Introduction
- Chapter 2
- Setting Up the System
- Setup Requirements
- Given Workstation
- DataRecorder and Cradle
- Storage Space for the PillCam Capsule Box
- Main Platform Components
- Connecting the Components
- Connecting the Given Workstation
- 1. Connect the Mouse cable to the Mouse connector.
- 2. Connect the Keyboard cable to the Keyboard connector.
- 3. Connect the monitor to the Workstation.
- 4. Connect the printer to the LPT connector or to the USB connector, depending on the printer’s connection cable.
- 5. If the Workstation’s voltage setting is manual, verify that the Workstation’s voltage matches the local voltage. If it does not, call Given Customer Support.
- 6. After voltage verification, connect the power cable of the Given Workstation to the electric outlet.
- 7. Connect the power cable of the monitor to the wall electric outlet.
- Connecting the DataRecorder Cradle
- Chapter 3
- Software Installation
- Chapter 4
- Multi-User Setup
- Chapter 5
- Technical Description
- System Labeling
- Essential Performance
- Warnings
- Cautions
- System Specifications
- PillCam SB Capsule
- PillCam SB 2 Capsule
- PillCam ESO 2 Capsule
- PillCam ESO 3 Capsule
- PillCam COLON 2 Capsule
- SensorArray DataRecorder 2
- SensorArray DataRecorder 3
- SB SensorBelt for DataRecorder 2 and DataRecorder 3
- DataRecorder 2 /2C
- Cradle DataRecorder 2
- DataRecorder 3
- Cradle DataRecorder 3
- DC Power Supply
- DataRecorder 3 Memory Card
- RAPID Software
- Guidance and Manufacturer's Declarations
- Chapter 6
- Maintenance
- Chapter 7
- Troubleshooting
PillCam Platform
46 Chapter 5
Cradle DataRecorder 2
DataRecorder 3
Properties
Weight 890 g
Size (without
battery inserter
14[D] x 165[W] x 97[H]mm
Color black
Mains power
connections
1x male power cable plug
power mains
range
100 to 240V
Properties
Physical Software Proprietary firmware
Recording capacity Up to 15 hours @ LCD OFF
Weight 500 g., including battery pack.
Operational Power 3.5–4.2 VDC, 0.15–0.5 A
Battery type Internal, Li-Ion, 3.8 V typical, 8800
mAH
Operating temp.
0–40
°C
Storage temp.
0–55
°C
Shielding No belt shielding
Classification • internally powered (complies
with requirements for Class I
equipment while connected to
supply mains through charger)
• Type BF applied part
• Ordinary equipment
Receiver (Rx) Operating frequency 434.1 MHz
Bandwidth of the receiving
section in this band
10 MHz
Transmitter Operating frequency 13.56 MHz
Frequency band ISM
Modulation type Linear Chirp
Type of modulated signal Digital data
Frequency of modulating
signal
20.25 dBm
Effective radiated power -27.4 dBm