User Manual
Table Of Contents
- Book 1: Setup & Maintenance
- Table of Contents
- Chapter 1
- Introduction
- Chapter 2
- Setting Up the System
- Setup Requirements
- Given Workstation
- DataRecorder and Cradle
- Storage Space for the PillCam Capsule Box
- Main Platform Components
- Connecting the Components
- Connecting the Given Workstation
- 1. Connect the Mouse cable to the Mouse connector.
- 2. Connect the Keyboard cable to the Keyboard connector.
- 3. Connect the monitor to the Workstation.
- 4. Connect the printer to the LPT connector or to the USB connector, depending on the printer’s connection cable.
- 5. If the Workstation’s voltage setting is manual, verify that the Workstation’s voltage matches the local voltage. If it does not, call Given Customer Support.
- 6. After voltage verification, connect the power cable of the Given Workstation to the electric outlet.
- 7. Connect the power cable of the monitor to the wall electric outlet.
- Connecting the DataRecorder Cradle
- Chapter 3
- Software Installation
- Chapter 4
- Multi-User Setup
- Chapter 5
- Technical Description
- System Labeling
- Essential Performance
- Warnings
- Cautions
- System Specifications
- PillCam SB Capsule
- PillCam SB 2 Capsule
- PillCam ESO 2 Capsule
- PillCam ESO 3 Capsule
- PillCam COLON 2 Capsule
- SensorArray DataRecorder 2
- SensorArray DataRecorder 3
- SB SensorBelt for DataRecorder 2 and DataRecorder 3
- DataRecorder 2 /2C
- Cradle DataRecorder 2
- DataRecorder 3
- Cradle DataRecorder 3
- DC Power Supply
- DataRecorder 3 Memory Card
- RAPID Software
- Guidance and Manufacturer's Declarations
- Chapter 6
- Maintenance
- Chapter 7
- Troubleshooting
PillCam Platform
18 Chapter 2
Given Workstation
The footprint of the Given Workstation is about 18 cm (W) x 47 cm (D) x 45 cm (H).
DataRecorder and Cradle
The cradle of any DataRecorder with its cable connections have a footprint of about 8-12
inches (20-30 cm).
The DataRecorder is kept in its cradle when not in use.
Storage Space for the PillCam Capsule Box
Provide a storage space that is protected from any powerful electromagnetic source, for stor-
ing the PillCam video capsule 1box.
Main Platform Components
Following is a list of items which you need to connect in order to set up the PillCam Platform:
• Given Workstation
• Monitor
• Keyboard
• Mouse
• Printer
• DataRecorder with Cradle
Connecting the Components
Warning
The Given Workstation has either an automatic or a manual Voltage Select
Switch. In case the workstation has a manual switch:
• verify that the workstation’s voltage is set according to the local voltage prior to
connecting the Given Workstation to the wall outlet.
• If the voltage is not set according to the local voltage, do not connect the system.
Call the Given
Customer Support.
Caution
!
Voltage mismatch will damage the Given Workstation.