User Manual
Table Of Contents
- Book 1: Setup & Maintenance
- Table of Contents
- Chapter 1
- Introduction
- Chapter 2
- Setting Up the System
- Setup Requirements
- Given Workstation
- DataRecorder and Cradle
- Storage Space for the PillCam Capsule Box
- Main Platform Components
- Connecting the Components
- Connecting the Given Workstation
- 1. Connect the Mouse cable to the Mouse connector.
- 2. Connect the Keyboard cable to the Keyboard connector.
- 3. Connect the monitor to the Workstation.
- 4. Connect the printer to the LPT connector or to the USB connector, depending on the printer’s connection cable.
- 5. If the Workstation’s voltage setting is manual, verify that the Workstation’s voltage matches the local voltage. If it does not, call Given Customer Support.
- 6. After voltage verification, connect the power cable of the Given Workstation to the electric outlet.
- 7. Connect the power cable of the monitor to the wall electric outlet.
- Connecting the DataRecorder Cradle
- Chapter 3
- Software Installation
- Chapter 4
- Multi-User Setup
- Chapter 5
- Technical Description
- System Labeling
- Essential Performance
- Warnings
- Cautions
- System Specifications
- PillCam SB Capsule
- PillCam SB 2 Capsule
- PillCam ESO 2 Capsule
- PillCam ESO 3 Capsule
- PillCam COLON 2 Capsule
- SensorArray DataRecorder 2
- SensorArray DataRecorder 3
- SB SensorBelt for DataRecorder 2 and DataRecorder 3
- DataRecorder 2 /2C
- Cradle DataRecorder 2
- DataRecorder 3
- Cradle DataRecorder 3
- DC Power Supply
- DataRecorder 3 Memory Card
- RAPID Software
- Guidance and Manufacturer's Declarations
- Chapter 6
- Maintenance
- Chapter 7
- Troubleshooting
Given Imaging Ltd. 17
Chapter 2
Setting Up the System
Setup Requirements
Set up your office to accomodate the new PillCam Platform. Review the following Workstation
specifications:
Four electrical outlets are required to connect the following components: Workstation computer,
monitor, printer, and one cradle. Each additional cradle requires an additional outlet.
Note
You may use a Given approved power strip.
Caution
!
Do not connect any component of the PillCam Platform to the same outlet as
any appliance or device that has a high power requirement (refrigerators,
generators, devices with motors, etc.). When setting up the system, make sure
that the total power requirements for all of the devices connected to a single
outlet or circuit do not exceed the rated limit for that circuit. If you are not sure of
the rated limit, please consult your maintenance department or an electrician.
Do not use a KVM Switch with the PillCam Platform.
The dimensions of the Workstation components are listed below:
Note
Extra space is needed for air circulation and cable connectors behind the
Workstation.