User Manual
Table Of Contents
- Book 1: Setup & Maintenance
- Table of Contents
- Chapter 1
- Introduction
- Chapter 2
- Setting Up the System
- Setup Requirements
- Given Workstation
- DataRecorder and Cradle
- Storage Space for the PillCam Capsule Box
- Main Platform Components
- Connecting the Components
- Connecting the Given Workstation
- 1. Connect the Mouse cable to the Mouse connector.
- 2. Connect the Keyboard cable to the Keyboard connector.
- 3. Connect the monitor to the Workstation.
- 4. Connect the printer to the LPT connector or to the USB connector, depending on the printer’s connection cable.
- 5. If the Workstation’s voltage setting is manual, verify that the Workstation’s voltage matches the local voltage. If it does not, call Given Customer Support.
- 6. After voltage verification, connect the power cable of the Given Workstation to the electric outlet.
- 7. Connect the power cable of the monitor to the wall electric outlet.
- Connecting the DataRecorder Cradle
- Chapter 3
- Software Installation
- Chapter 4
- Multi-User Setup
- Chapter 5
- Technical Description
- System Labeling
- Essential Performance
- Warnings
- Cautions
- System Specifications
- PillCam SB Capsule
- PillCam SB 2 Capsule
- PillCam ESO 2 Capsule
- PillCam ESO 3 Capsule
- PillCam COLON 2 Capsule
- SensorArray DataRecorder 2
- SensorArray DataRecorder 3
- SB SensorBelt for DataRecorder 2 and DataRecorder 3
- DataRecorder 2 /2C
- Cradle DataRecorder 2
- DataRecorder 3
- Cradle DataRecorder 3
- DC Power Supply
- DataRecorder 3 Memory Card
- RAPID Software
- Guidance and Manufacturer's Declarations
- Chapter 6
- Maintenance
- Chapter 7
- Troubleshooting
PillCam Platform
14 Chapter 1
External Power Supply
The Cradle is connected to the mains power through an external power supply.
Caution
!
Use only this power supply.
RecorderPouch
The DataRecorder 3 RecorderPouch is a pouch with an adjustable strap to hold the DataRecorder.
The patient must wear the DataRecorder at all times while the PillCam video capsule is active
inside the patient. Use the waist strap to anchor the DataRecorder and the SensorArray connector
to the patient’s body.
SB SensorBelt
The SB SensorBelt receives data from the PillCam video capsule and transfers it to the
DataRecorder. The sensor is connected to the DataRecorder module by a flexible cable and is
worn at the waist of the patient over a thin shirt. The SB SensorBelt is used for PillCam capsule
endoscopy of the small bowel.
SensorArray
The SensorArray receives data from the PillCam capsule through the sensors and transfers it to
the DataRecorder. Each sensor is connected to the DataRecorder module by a flexible cable. The
sensor is built of a flexible printed circuit board (PCB) and is attached to the skin by means of a
disposable, medical adhesive sleeve.
The SensorArray used in a capsule endoscopy depends on the caspule type and the DataRecorder
type:
• 8-lead SensorArray: used with DataRecorder 2 and PillCam SB and PillCam COLON
capsules