User's Manual

Capsule Endoscopy
Given Imaging Ltd.
88
The Battery Pack should be charged only with the charger
supplied by Given® Diagnostic Imaging System.
After removing the sensors from the adhesive sleeves, clean
them before storing.
! To receive the examination set
1. Disconnect the Data Recorder from the Battery Pack.
2. Take the Data Recorder and the Battery Pack out of the
belt.
Recharge the Battery Pack. For instructions refer to
Charging the Battery Pack
on page
88
.
3. Carefully remove adhesive sleeves from sensors. This
can be done easily by tearing them in the middle along
the perforation.
4. To clean the Sensor Array, wipe it lavishly with 90%
alcohol and let it air-dry for 20 minutes.
5. When the Sensor Array is dry, return it to the Carrying
Case in which they were supplied.
6. To download the data from the Data Recorder, refer to
Creating a PRR Movie
on pate
46
.
Charging the Battery Pack
Use only a fully charged Battery Pack. Since even fully
charged batteries discharge slowly, recharge the Battery Pack