User's Manual

Capsule Endoscopy
Given Imaging Ltd.
82
10. To secure the Sensor Array cable to the left side of the
patient’s body, use the remaining adhesive pads as the
following scheme shows:
11. Instruct the patient to get dressed. The Sensor Array
connector and approximately 10 inches of cable should
remain outside of the patient’s clothes.
Putting the Belt on the Patient
Since you adjusted the belt, putting it on the patient is very
quick and simple.
! To put the belt on the patient
1. While the patient is standing, place the Recorder-Battery
Pack belt around the patient’s waist.
Note:
The Sensor Array connector and wire should dangle from above
the belt.
2. To connect the Sensor Array to the Recorder, insert the
Sensor Array 8-pins male connector to the 8-pins Female
connector at the top of the Recorder. Verify that the
protrusion of the Sensor Array connector is facing
outwards.