User's Manual

Capsule Endoscopy
Given Imaging Ltd.
81
2. To secure the sensor in the sleeve, remove the liner from
the adhesive line at the opening of the adhesive sleeve
and press both lips together.
3. Ask the patient to lie down and to expose his/her stomach
area down to the pubic bone.
4. If a male patient arrives unshaven, wipe the patient’s
abdomen with disinfectant and shave the abdomen 6
inches above and below the umbilicus (navel).
5. To mark the location of each sensor, place the Sensor
Template on the patient’s stomach with the drawing
facing up while using the navel as a reference point and
insert the marker into the holes. Mark the location of
each sensor.
6. Remove the Sensor Array Template from the patient and
keep it for reference until you complete the procedure.
7. Place the Sensor Array on the patient’s abdomen using as
a guideline the numbers on each sensor wire and the
numbers on the Sensor template. The Sensor Array
connector should be at the LEFT SIDE of the patient.
8. To attach each sensor, start with the rightmost sensor.
Remove the protective backing from its Adhesive Sleeve.
Secure the sensor to the patient’s abdomen so that the
hole at the center of the sleeve approximately overlaps
the marking on the patient’s abdomen.
9. Repeat step 1 - 8 for all sensors.