User's Manual

Capsule Endoscopy
Given Imaging Ltd.
76
Connecting Belt Components
This section instructs you on how to connect the Battery Pack
to the Recorder and how to secure both Battery Pack and the
Data Recorder in their pouches.
Note:
Since fully charged batteries slowly discharge, use only a Battery
Pack you have just charged. For information on how to charge the
Battery Pack, refer to
Charging the Battery Pack
on page
88
.
! To connect belt components
1. Place a recently fully charged Battery Pack in the battery
belt pouch.
2. To connect the Battery Pack to the Data Recorder,
connect the 9-pin Female connector of the Battery Pack
cable to the 9-pin Male connector of the Data Recorder.
3. Secure with the securing screws.
Note:
While connecting the Battery Pack to the Data Recorder, hold the
Data Recorder.
The Data Recorder green LED blinks, turns on and then
off. Once the recording starts the LED blinks at the
receiving rate.
4. Insert Data Recorder into the Data Recorder pouch, and
bring the Battery Pack cable out from the top opening of
the pouch. (See the following picture).