User's Manual

Know Your PillCam Recorder
PillCam Recorder DR3 65
Turning On and Off
The illustration below shows the PillCam recorder DR3 sitting in the cradle:
The PillCam recorder DR3 is automatically ON when it is in its cradle.
When removed from the cradle, it may be turned off and on again using the On/Off button.
The On/Off button is on the left side of the PillCam recorder DR3:
• To turn on, press and hold the On/Off button for 5 seconds until you see the startup screen. All
LEDs start to flash. (The full start-up sequence takes about one minute.)
• To turn off, press and hold the On/Off button for 5 seconds until the PillCam recorder DR3 beeps
and the screen turns off and the button LEDs turn black.
֠
֠֠
֠
Note
Automatic Shutdown:
• After the PillCam recorder DR3 has been checked in, it goes into standby
mode ready to receive capsule signals when removed from its cradle. If
after 90 minutes no capsule pairing is performed, the PillCam recorder
DR3 automatically shuts down.
• After starting to receive signals from a paired capsule, if there is a gap of
30 minutes with no signal reception from the paired capsule, the PillCam
recorder DR3 will shut down.
֠
֠֠
֠
Note
When the PillCam recorder DR3 is on, its screen backlight goes into an off
mode if the screen or recorder controls are idle for more than 3 minutes. If
the PillCam recorder DR3 is on, but the screen is off, press any key to turn
the screen on. Once the PillCam recorder DR3 screen is activated, proceed
with pressing the desired function button.
ON/OFF
button
Acknowledge button
Capsule and message LEDs
Line for
status icons
Message area
Navigation
buttons
Cradle