User's Manual

4.6 2.5” SATA HDD/SSD Installation

1. Remove the bottom four M2.5*5mm screws to remove the bottom cover.

2. Open the bottom cover and unplug the cable connected to the board on the

inside of the bottom cover.

3. Remove the two M2.5*6mm screws securing the DIO module and remove the DIO

module.

4. Remove the M2.5*8mm screw to securing the IOM-2RG module and remove the

IOM-2RG module.

5. Remove the Plastic Pillars.

6. Remove the IOM-POEAT4 module.

7. Plug the SATA power cable into the SATA power wafer connector on the board. Then

plug the SATA cable (without lock) into the SATA connector on the board.

8. Install the IOM-POEAT4 module and secure with M2.5*6mm screw.

9. Install the Plastic Pillars.

10. Insert the IOM-2RG module and secure with M2.5*8mm screw.

11. Install the 2.5” SATA disk drive to the bottom cover with 4 M3x4mm screws and insert

the SATA cable (with lock) and SATA power cable into the 2.5” SATA disk drive.