Installation Guide

7
All electrical conductors MUST BE PROTECTED against the water jet.
SHORT CIRCUIT
HAZARD
The appliance MUST ONLY BE CONNECTED to an adequate power supply in
compliance with all applicable regulations.
ELECTRIC SHOCK HAZARD
Use of a safety residual current circuit-breaker (R.C.C.B) will provide additional
protection for the operator:
Appliance without plug MUST be installed by qualified staff;
Use only authorized electrical extension leads with suitable conductor gauge.
High pressure may cause parts to rebound: wear all the protective clothing and
equipment needed to ensure the operator’s safety.
INJURY HAZARD
Plug MUST be pulled out after shutting the appliance or the appliance might start
automatically or burn itself;
Holding the gun firmly before triggering it.
INJURY HAZARD
COMPLY WITH the requirements of the local water supply company. According to
EN 12729(BA), the appliance may only be connected to the mains drinking water
supply if a back flow prevented valve with drain facility is installed in the supply hose.
1.
2.
3.
4.
5.
6.
7.
8.
SAFETY “MUSTS”
Connecting or replace plug and electrical cable MUST be carried out by qualified staff;
DO NOT pull fiercely when discharging the plug;
Electrical cable should be far away from fire and sharp object;
Cut the power supply immediately in case of breakdown or stop and find out the
reason before re-start the appliance;
To be sure the appliance standing on dry surface.
21.
22.
23.
24.
25.