Installation Guide

10 11
Tips: Please measure the correct drill bit width to use. Ensuring the wall anchors have
a secure fit, you may drill slightly under size since masonry materials all have different
sizing properties.
Note: Please install the pressure washer at a height of approximately 24-32in above
the ground to maximize the function of auto-retraction.
Use the installation template to mark the location of the 4 holes.
Use a drill bit with a diameter of 12mm (recommend a 29/64" or 15/32" or 31/64" drill)
and a length of more than 100mm / 3.94in. to drill 60mm / 2.36in. deep holes. Please
ensure the diameter after drilling is between 12mm / 0.47in. to 12.5mm / 0.49in.
Hammer the wall anchor into the 4 holes.
Hold the bracket base in place, put the nut in and then tighten it.
1.
2.
3.
4.
Installing the Bracket
Tips: Depth and the diameter after drilling are important. If the hole is too deep and
the wall anchor is rotating, use a matchstick or similar tool to tighten the hole tightly.
Note: The rotating bracket is designed to fix the pressure washer without shaking
during use.