Operation Manual

6
2. Insert the memory card into the slot.
To insert the battery:
1. Invert the back of the mobile phone upward and then take off the rear cover according
to the figure below.
2. Insert the battery as shown in the following figure.
3. Finally place back the rear cover of the mobile phone.
Charger
1. Connect the charger to the charger jack on the phone.
2. Next connect the charger to a power socket, the charging starts, with the charging icon
in an animated state.
3. When the charging icon becomes static, it indicates that the battery is full.
4. Disconnect the charger from the power socket and the phone.
Note: Slight heating during charging is normal. It indicates that the battery is full, when the
charging icon becomes static.