Installation & Assembly

KUBIC
LIGHT
INSTALLATION INSTRUCTIONS:
THESE LIGHTS SHOULD BE INSTALLED BY A LICENSED ELECTRICAL CONTRACTOR.
POWER REQUIREMENTS: 100-120 VOLTS
SAFETY: TO PREVENT ELECTRICAL SHOCK, BE SURE THAT THE POWER IS OFF BEFORE STARTING INSTALLATION.
NOTES TO INSTALLER:
A. THE BACKPLATE OF THIS FIXTURE WILL COVER A HOLE WITH A MAXIMUM DIAMETER OF 3 3/8” (86 mm).
THE CROSSBAR IS DESIGNED TO MOUND DIRECTLY ONTO A 3” DIAMETER ROUND RAISED COVER PLATE (ALSO
CALLED A ROUND PLASTER RING OR A ROUND RAISED MUD RING.) THE COVER PLATE SHOULD NOT PRO-
TRUDE FROM THE FINISHED WALL SURFACE.
B. THIS LIGHT MAY BE INSTALLED INVERTED IF PREFERRED.
INSTALLATION:
1. INSTALL CROSSBAR ONTO RAISED COVER PLATE.
2. CONNECT THE HOUSE GROUND WIRE TO THE CROSSBAR WITH THE ATTACHED GREEN GROUND SCREW.
3. FEED THE LIGHT FIXTURE WIRES THROUGH THE SPINDLE ON THE CROSSBAR.
4. CONNECT THE WHITE WIRES OF THE FIXTURE TO THE HOUSE NEUTRAL (WHITE) WIRE WITH A WIRENUT.
5. CONNECT THE BLACK WIRES OF THE FIXTURE TO THE HOUSE HOT (BLACK) WIRE WITH A WIRENUT.
6. SLIDE THE FIXTURE OVER THE SPINDLE OF THE CROSSBAR UNTIL THE BACKPLATE IS FLUSH AGAINST THE
WALL. TIGHTEN THE SETSCREW WITH THE PROVIDED WRENCH.
7. INSTALL LIGHT BULBS.
8. SCREW SHADES ONTO THE FIXTURE. DO NOT OVERTIGHTEN.
ID 36.00.21.26pdf 3 - 27 - 06