GRAB BAR INSTALLATION INSTRUCTIONS Model No: 2760 and 4560 2760 4560 2001 CARNEGIE AVE, SANTA ANA CA 92705 (949) 417-5207 WWW.GINGERCO.
ITEMS INCLUDED TOOLS REQUIRED SAFETY GLASSES DRILL GRAB BAR ASSEMBLY (BAR FROM 2760 SHOWN) X1 PHILLIPS SCREW DRIVER PEN / PENCIL 7/64” DRILL BIT #10 WOOD SCREW X8 LEVEL SET 1/4" CARBIDE TIP DRILLBIT (if drilling through ceramic tile) STUD FINDER GNG-2760 EN-2736 REV A Page 2 of 4
SAFETY WARNINGS 1.DO NOT install this equipment without first reading and understanding this instuction sheet. If you are unable to understand these Warnings and Instructions, contact a health care professional, dealer or technical personnel for assistance before attemping to install this equipment- otherwise, injury may occur. 2.After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely. 3.
Figure 1 Figure 2 wood wall stud wood wall stud top wood screw wall board wood wall stud TOP VIEW HORIZONTAL MOUNT wood wall stud wood screw NORMALLY 16” CENTER TO CENTER FRONT VIEW HORIZONTAL MOUNT wood wall stud grab bar wood wall stud wall board SIDE VIEW VERTICAL MOUNT Figure 3 wood wall stud FRONT VIEW VERTICAL MOUNT O-ring #10 Wood Screw End post Mounting Flange NORMALLY 16” CENTER TO CENTER Grab Bar Escutcehon USING GRAB BAR: 1.
