Installation Guide

INSTALLATION:
1. Provide the required wiring to the wall-mounted electrical box. The
electrical box should be flush in the wall.
2. Mount crossbar to the electrical box. The crossbar should be flat
against the wall with the spindle facing away from the wall.
3. Connect house ground wire to the crossbar with attached
ground screw.
4. Feed the light fixture wires through the rosette then through the
center hole of the crossbar.
5. Connect the white wire of the fixture to the house neutral wire
with a wirenut.
6. Connect the Black wire of the fixture to the house hot wire
with a wirenut.
7. Slide the fixture over the spindle of the crossbar until it is flush
against the wall. Secure the fixture by tightening the set screw with
the provided wrench. Make sure the wires are not pinched during
this process.
8. Position glass shade onto fixture and tighten thumb screws.
9. Install light bulbs.
Installation Instructions:
These lights should be installed by a licensed electrical contractor.
POWER REQUIREMENTS: 120 Volts, 60 Cycles
NOTE: This light may be inverted for uplighting.
SAFETY: TO PREVENT ELECTRICAL SHOCK, BE SURE THAT POWER IS OFF
BEFORE STARTING INSTALLATION.