Installation Instructions

1 Measure the distance between
the pillars. (See Figure A.)
2 If the distance is 6' or less you will need
one six foot wide fence section and
one package of *wall fittings. The
fence will need to be cut to fit be-
tween the pillars exactly.
To maintain equal spindle spacing we
recommend cutting equal amounts from both ends of the fence section.
3 If the distance to be fenced is over 6’ you will need one set of Wall Fittings, two
6’ long fence sections and
one line post for each ad-
ditional 6’ or fraction to be
fenced.
(See Figure B).
If the area under the fence
is grass or earth the post will
have to be set in cement
as shown.
*
marks the locations of the Wall Attachment Fittings on all
illustrations.
Transition Post
SITUATION:
HILLSIDES & SLOPES
All standard fence sections adjust to hills
as steep as 1' in a 6' run. If greater ad-
justment is required special sections
must be ordered with greater
adjustability.
Fence Attached to Walls or Pillars
(If the pillars do not exist and are to be built, it is best to make them a multiple of 6’ apart.)
SPECIAL SITUATIONS
Here are suggested solutions to vari-
ous situations which may arise with
your fence installation.
SITUATION:
CHANGING HEIGHTS
There may be occasions where you will
want to put 2 different fence heights
together.
Special Situations (during planning and installation)
1 ft. Slope
SOLUTION:
If slope is greater than 1' in 6' order spe-
cial sections which can be adjusted up
to 45°.
SOLUTION:
“Special Order” a “Transition Post”
HOW TO ORDER:
1. Specify Line Post or Corner Post
2. Specify the two heights needed
3. If a Corner Post—specify direction
of corner
SITUATION:
NON – “RIGHT ANGLE” CORNERS
120° Angle
Angle
SOLUTION:
Install the corner post at an angle using
a swivel attachement fitting.
6'2' 2'
Posts set under surface
Figure B
4 If the area directly under the fence is brick, wood
or concrete you will need Fence Post Bases with
which to fasten down the post.
(See Figure C).
6'
Figure A
Short End Sections (Cut 2 sections)
CUTTING SECTIONS TO FIT ODD MEASUREMENTS
Fence Post Base
Figure C
Short Center Section (Cut 1 section)
3 Equal Lengths (Cut all sections)
120º Angle
PAGE 4PAGE 4
PAGE 4PAGE 4
PAGE 4