Owner's manual

Stop at End Commands
“%” (track#) Stop at End Track:
“&” Stop at End Global:
“'” Stop at End Cocked:
“(” (group) Stop at End Group:
These commands reset the cycling mode in the se-
lected Smart Brick Brain(s) . What this dies is to stop them
playing when the end of their current shows are
reached. The STOP commands are used when you
want to stop a show immediately. These commands are
used when you want the shows to finish gracefully.
If the ‘ALLOW CHAINS’ option has been selected on a
Smart Brick Brain, then any immediate jumps to whatev-
er the next show is will take place even after the cycling
mode has been stopped by using these commands
Select Show Commands
“)” (track#) (show#) Select Show Track:
“*” (show#) Select Show Global:
“+” (show#) Select Show Cocked:
“/” (group) Select Show:
Up to two hundred fifty-five different animated shows
can be stored on a single Smart Brick System. These
commands can be used to select an individual show
on the selected Smart Brick Brain(s). Individual shows can
be requested with SHOW# requests with a range of 01 to
3Fh (01 to FFH with a Rack Smart Brick Brain). Once a
show is selected, it will be played on the next start (the
start can come from a serial port command, a hard-
ware input command, or at the end of the normal
countdown between shows if the Smart Brick Brain is cy-
cling. When it has finished playing the requested show
(or sequence of shows), you have the option of letting
the Smart Brick Brain return to what would have been the
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
46 of 178