Owner's manual

k 0 0 40
This would tell you that the Smart Brick Brain is currently
running a Smpte clocked show.
“l” (track#) Switch Status:
This command responds with the following informa-
tion for the Smart Brick Brain specified by the TRACK#:
BIT 0 = GREEN INPUT STATUS (1 = closed)
BIT 1 = BLUE INPUT STATUS (1 = closed)
BIT 2 = PB INPUT STATUS (1 = closed)
BIT 3 = not used
BIT 4 = THUMBWHEEL SWITCH BIT 0
BIT 5 = THUMBWHEEL SWITCH BIT 1
BIT 6 = THUMBWHEEL SWITCH BIT 2
BIT 7 = THUMBWHEEL SWITCH BIT 3
EXAMPLE: to poll the input switch status for Smart Brick
Brain 00:
l0031
This would tell you that the Smart Brick Brain has the
thumbwheel switch set to ‘3’, and that their is an input
present on the GREEN input.
“m” (5AA5) (track#) Enter Setup Mode:
This command puts the Smart Brick Brain specified by
the TRACK# into the configuration mode. All other Smart
Brick Brains in the system are locked off from receiving
any serial commands when there is even one Smart
Brick Brain in configuration mode. They will not accept
any serial commands until they hear the commands to
exit configuration mode being sent to the one Smart
Brick Brain which is in this mode. For details on the config-
uration mode, see the configuration section of this man-
ual.
EXAMPLE: to put Smart Brick Brain 00 into setup mode:
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
39 of 178