Owner's manual

first button pushed will be played at the next START or
START LOOPING command, unless it is overridden by an-
other show request from the serial ports. (The Brain can
also be told to start playing the newly requested show
immediately if you tell the Smart Brick Brain to START or
START LOOPING on the input to the 1/4 J-6 port.)
If this mode is off, then up to two hundred fifty-five dif-
ferent shows can be selected through the 1/4 J6 Port.
The 1/4 J6 Port can be connected directly to the output
of a computer or Animation Control System. If you need
to connect it to pushbuttons, you will need to use diodes
or a keyboard with an encoder (available from
Gilderfluke & Company) to encode a binary number to
be sent to the 1/4 J6 Port.
As with changes in inputs on the A, B, or PB input,
changes on the 1/4 J6 Port can be used to START, stop,
or whatever a Smart Brick Brain. If the DIRECT SELECT op-
tion is 'on', then a rising edge is on any new arrival of a
new closure, and a falling edge is when all input lines
are opened. If the DIRECT SELECTION is 'off', then a rising
edge is on any change in the 1/4 J6 Port except for
when all of the inputs go open, which is considered to
be a falling edge.
“m” More.....:
This command allows you to select from the other
menus:
1) Main Menu. This brings you back to the main
menu.
2) Show Setup. This will ask you which of the 255 possi-
ble shows you want to modify.
3) String Setup. This allows you to modify the strings
used to control LaserDisk (or DVD)s.
4) Delay. This allows you to set how long each of the
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
117 of 178