User guide

AB-Clock Serial Port Command:
This command will only be accepted by the AB-Clock when it is not al-
ready in configuration mode.
"s" (TRACK#) (STRING) Load Configuration:
This command loads the string that follows it into the configuration
EEprom for the AB-Clock. This command is used to load the configuration
into an AB-Clock. Since the CONFIGURATION DUMP command leads off its
string with a 's5AA5', data saved in the configuration dump command can
be reloaded into the audio system by simply sending back to it.
To do this:
1) Tell your modem program to delay slightly between characters so
you donÕt over run the input buffer of the AB-Clock (or lower the
baud rate).
2) Tell your computer to send out the previously saved output string
from the CONFIGURATION DUMP command.
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
Summary of AB-Clock Command:
"s" (TRACK#) (STRING) Load Configuration:
GILDERFLUKE & CO. ¥ 205 S. FLOWER ¥ BURBANK, CA 91502-2102 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX [phone]
49 of 72