Instructions / Assembly

Page 3 of 307/28/21
Customer Service: 847-821-9646
Assembly 5 for four previously assemblies using
Screw with Wing Nuts (H).
Hint: Lay on a at surface. Start with Assembly
1 with curved sections facing to the right. Next,
place the Assembly 2 to the left of Assembly 1
with the curved sections facing down. Next, place
Assembly 3 to the left of Assembly 2 with the
curved sections facing up. Next, place Assembly
4 to the left of Assembly 3 with the curved
sections facing to the left.
(FIG 1) Position the basket tree on a hard level
surface. For maximum stability, drill and plug
holes in a paving slab or similar surface and screw
down through the holes in the fet. Do NOT use
on soft ground unless each foot is pegged into a
concrete pocket using the Ground Pegs (G)
(FIG 2) Attach Hooks (L) to the top sections
and hang the Hanging Baskets (M) on the hooks.
Place the Liner (N) in the baskets.
Assembly 5
Typical Hardware
3 Places
H
Assembly 1
Assembly 1
Assembly 2
Assembly 2
Assembly 3
Assembly 3
Assembly 4
Assembly 4
G
Bottom Sections
N
L
M
Top Sections
FIG 1 FIG 2
Copyright © 2021
Midwest Air Technologies, Inc.
6700 Wildlife Way
Long Grove, IL 60061