User's Manual

D-Cam Clip-On Operators Manual Issue 1 Page 21 of 21
UNUM-CCAM -0104
5.1.3 Audio Connector
Line / Mic Hi Z
5 Pin Lemo Plug FGG.1B.305.CLAD62Z
Pin Function Notes
1 0V (Screen)
2 Ch1 +
3 Ch1 -
4 Ch2 +
5 Ch2 -
Analogue
47kOhm differential
5.1.4 Power Connector
9-18V DC 18W (Clip-On power only)
This connector can be used to take power from the docked battery (5A Max) to power
external cameras if the D-Cam Clip-On is not docked directly to the camera, or feed power
into the D-Cam Clip-On and then forward into the camera.
Note: A diode is fitted to prevent the external power supply from ‘back feeding’ into the
battery.
The power switch is used to control the D-Cam Clip-On only. The power supply to the
camera is always available from the battery interface or external power connector. The
camera on/off switch should therefore be used to control the camera independently.
4 Pin Lemo Plug FGG.1B.304.CLAD62Z
Pin Function
1 0V
2 0V
3 +12V
4 +12V
5.1.5 Remote Connector
RS232. 19200 Baud, 8 bit, 1 stop, No parity
4 Pin Lemo Plug FGG.0B.304.CLAD62Z
Pin Function
1 0V
2 Tx (Data out from unit)
3 Rx (Data into unit)
4 0V