Operation Manual

40
Working with the Gigaset N720 SPK PRO
Gigaset N720 DECT IP Multicell System / engbt / A31008-M2316-L101-2-7619 / mess_kit.fm / 10.02.2012
Version 2, 06.08.2010
Changing the settings for metering mode
In the service menu, you can change the unit of measure and the measurement interval
for metering mode.
§Start§ Press the display key to activate metering mode.
§Back§ Press the display key to exit the service menu again.
The handset is deactivated. When you reactivate it, it is in metering mode with the
selected settings.
Metering Mode (unit of measure)
In the display, the signal strength (RSSI value) is displayed
in dBm as standard. You can also display the signal
strength as a percentage value. This represents the signal
strength of the package received as a ratio of the maxi-
mum possible RSSI (100%).
r Use the navigation key to select the desired display
of the signal strength.
dBm: The signal strength measured is displayed in
dBm. This is preset and is the recommended mode.
%: The signal strength measured is displayed as a
percentage of the maximum RSSI
SEN: Not relevant
Metering range (measurement interval)
The measurement interval defines the time intervals at
which measurements are taken.
Value range: 06–16 (1.0 s–2.5 s)
Recommended value: 16
r Use the navigation key to select the required meas-
urement interval.
Metering Mode:
<dBm
Metering range:
06
Back Change
RSSI measurement
>
Metering Mode:
dBm
Metering range:
< 06
Back Start
RSSI measurement
>
Please note
You should not make changes to other settings in the service menu.