Operation Manual

Taking measurements

Gigaset N720 DECT IP Multicell System / engbt / A31008-M2316-L101-2-7619 / measure.fm / 10.02.2012

Version 2, 06.08.2010

Evaluating measurements

The graphical display of your measurement results in the layout plan shows the overlap

areas of the individually planned base stations.

In the example, limitation lines are drawn for the wireless coverage for base stations A and

D. The overlap areas are very good for both stations; synchronisation is also guaranteed

between A and D. However, the measurement results of the other stations must be used

to check whether a further base station is required in the shaded areas.

¤ Using the measurement results (where necessary), define new positions for the base

stations and check them with further measurements.

Note that moving one installation location also influences the other measurement

results. Always consider how this affects the synchronisation of the base stations.

¤ Enter the determined optimum installation locations for the base stations in the plan

(including the height and special construction circumstances, if necessary). We recom-

mend you also document the assembly positions with photographs.

¤ In particular, check rooms or areas with very high wireless signal shielding (e.g., lifts,

reinforced concrete ceilings, etc.) and add further base stations to your plan where

necessary.

Once the measurements are complete and the positions of the base stations have been

defined, the telephone system can be installed. This is described in the user guide for the

Gigaset N720 IP PRO and Gigaset N720 DM PRO.

Recommendation

After installation and commissioning of the DECT network, the voice quality, roaming

and handover should be checked again with the system telephones.