Operation Manual

10
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Handset
Gigaset E560A / LUG NLD-BEL en / A31008-M2708-M201-1-3F19 / starting.fm / 1/31/17
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the battery and closing the battery cover
Charging the batteries
¤ Charge the batteries fully prior to first use in the
charging cradle/base.
The batteries are fully charged when the power
icon disappears from the display.
Only use a rechargeable battery, as this could otherwise result in significant health
risks and personal injury. For example, the outer casing of the battery could be des-
troyed or the battery could explode. The device could also malfunction or be dama-
ged as a result of using batteries that are not of the recommended type.
¥ Insert the batteries (for
correct +/- direction, see
diagram).
¥ Fit the cover from the top .
¥ Then press the cover until it
clicks into place .
1
2
To open the battery cover:
¥ Push the cover down .
3
1
2
3
Batteries may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base. In the
event that a handset is not registered however, (indicated by "Please register hand-
set"), register the handset manually ( S. 42).