Operation Manual

13
Gigaset E560A / LUG NLD-BEL en / A31008-M2708-M201-1-3F19 / operating.fm / 1/31/17
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Getting to know your telephone
Volume keys
During a call or when listening to a message, set the volume for the receiver/headset or speaker
or in the case of an incoming call, set the volume of the ringtone (5 levels).
¤ Press the volume keys on the right side of the handset:
(louder) / (quieter)
The current setting is permanently saved after approx.
two seconds (
p. 45).
Extra-loud function
¤ Press the top volume key until you reach the highest
level.
The extra-loud setting only applies for the duration of the call.
Direct dialling keys A to D
You can save important phone numbers that you call often to the four direct dialling keys. You
can assign an external phone number to each direct dialling key.
To dial these saved numbers, press the relevant direct dialling key to on the handset or
on the base.
You can also assign the emergency function to direct dialling key ( p.26).
Assigning a function to direct dialling keys
Prerequisite: The direct dialling key in question has not already been assigned a function.
¤ In idle status, press the direct dialling key ( to ) on the handset to which you wish to
assign a function.
Select the relevant function using :
¤ Label with Ext. No.
Enter an external phone number directly.
¤ Label with Internal Call
Direct dial to a handset registered to the same base.
If more than one other handset is registered: Select handset OK
¤ Label with Call All Int.
Direct dial to all handsets registered to the same base.
Volume:
Back OK
•
This setting can result in harm to health in persons with a normal hearing ability
and is only intended for persons with a hearing impairment or reduced hearing.
• Disruptive noises on the phone line can be increased.
Enter the number and press OK.
Enter the name and press OK.