Operation Manual

60
Gigaset C530 / LUG ZAF en / A31008-M2512-W101-1-7619 / appendix.fm / 6/26/13
Template Borneo, Version 1, 21.06.2012
Customer Service & Assistance
Authorisation
This device is intended for connection to analogue networks outside the European Economic
Area (with the exception of Switzerland) depending on national type approval.
Country-specific requirements have been taken into consideration.
We, Gigaset Communications GmbH, declare that this devic
e meets the essential requirements
and other relevant regulations laid down in Directive 1999/5/CE.
A copy of the Declaration of Conformity is available at this Internet address:
www.gigaset.com/docs
The other party cannot hear you.
The handset is "muted".
¥ Activate the microphone again (¢ page 22).
The caller's number is not displayed.
1. Calling Line Identification (
CLI) is not approved for the caller.
¥ The caller should ask the network provider to enable Calling Line Identification (CLI).
2. Caller display (CL
IP) is not supported by the network provider or is not enabled for you.
¥ Caller display (CLIP) is enabled by the network provider.
3. Your telephone is connected via a PABX or a router w
ith an integrated PABX (gateway) that does not
transmit all information.
¥ Reset the system: Briefly pull out the power plug. Reinsert the plug and wait until the device restarts.
¥ Check the settings on the PABX and activate phone number display, if necessary. To do this, search for
terms such as CLIP, calling line identification, phone number identification, caller ID, etc. in the
system's user guide or ask the system manufacturer.
You hear an error tone when keying an input.
Action has failed/invalid input.
¥ Repeat the process.
Read the display and refer to the user guide if necessary.
You cannot listen to messages
on the network mailbox.
Your PABX is set to pulse dialling.
¥ Set your PABX to tone dialling.