Operation Manual

9
A68H (A38H) / CHINA / A31008-M2054-Y101-2-5D19 / main.fm / 15.04.2011
Appendix
Entering letters/characters
Press the required key the number of times indicated.
Briefly press the hash key # to switch from "Abc" to
"123" mode, from "123" to "abc"mode and from "abc"
to "Abc" mode.
Standard characters
1) Space
Specifications
Recommended batteries
Technology: Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 400–800 mAh
We recommend the following types of battery:
◆ GP 550/700 mAh
◆ Yuasa Phone 700/800 mAh
◆ Peacebay 550/650 mAh
(Valid at the time of going to press)
The handset is supplied with recommended
batteries.
General specifications
Customer Care and support
Hotline: [phone]
Questions and answers
If you have any queries about the use of your phone,
you can contact us any time at
www.gigaset.com/cn.
Or call hotline [phone].
The table below contains a list of common problems
and possible solutions.
1x 2x 3x 4x 5x 6x 7x 8x 9x 10x 11x 12x 13x 14x
1
1 £ $ ¥ ¤
2
a b c 2 ä á à â ã ç
I
d e f 3 ë é è ê
4
g h i 4 ï í ì î
5
j k l 5
L
m n o 6 ö ñ ó ò ô õ
M
p q r s 7 ß
N
t u v 8 ü ú ù û
O
w x y z 9 ÿ ý æ ø å
Q
. , ? ! 0 + - : ¿ ¡ " ’ ; _
P
* / ( ) < = > %
#
Abc
-->
123
123
-->
abc
# @ \ & §
1)
WDCT standard is supported
No. of channels 80 duplex channels
Radio frequency range 2400-2483.5 Mhz
Duplex method Time multiplex,
10 ms frame length
Bit rate 576 kbit/s
Modulation GFSK
Transmission power 25 mW, average power per
channel
Range up to 300 m outdoors
up to 50 m indoors
Base station power supply 230 V ~/50 Hz
Environmental conditions
in operation
+5 °C to +45 °C; 20% to 75%
humidity
Dialling mode DTMF (touch tone dialling)/
DP (dial pulsing)
Problem Cause Solution
Nothing
appears in
the
display.
The handset is
not
switched on.
The batteries
are flat.
Press the end call key
a for approx.
5
seconds or place the
handset in the base
station.
Charge or replace the
batteries.
No wireless
connection to
the base sta
-
tion, Base
flashes in the
display.
The handset is out-
side the range of
the base station.
The handset is
not
registered.
The base station
is
not turned on.
Move the handset
closer to the base
station.
Register the handset
¢ page 5.
Check the mains plug
on the base station.