Operation Manual

A68H (A38H) / CHINA / A31008-M2054-Y101-2-5D19 / Version 4, / starting.fm / 15.04.2011
5
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base station.
The
actual registration procedure will depend on the type of base station.
Automatically register the A68H handset to the Gigaset A680/A685 base station
Manually registering the A68H handset
You must activate manual registration of the handset on both the handset and the
base
station.
1. On the handset: MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS
¢ Enter the base station system PIN (default setting: 0000) ¢ OK.
2. On the base station: Within 60 sec. of entering the system PIN, press and hold the registra-
tion/paging key (min. 3 sec.). See also the user guide belonging to the base station.
After successful automatic or manual registration, the idle display is shown:
The handset is assigned the lowest unassigned internal number (1–4). If more than one hand-
set is registered to the base station, the internal handset number appears in the top left of the
display, e.g. 2. If the internal numbers 1–4 are already assigned to other devices, the number
4
will be overwritten.
Please note
Only place the handset in the base station or charging cradle that is intended for it.
V
Registering
The handset registers automatically. Reg-
istration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
V
Register HS
MENU
¤ Place the handset with
the display facing up in
the base station.
V
Registering
The registration screen is displayed.
V
INT MENU
Charge status of the batteries:
–
= e V U (flat to full)
–
= flashes: batteries almost flat
–
e V U flashes: charging