Operation Manual

A39H
/
ARG
-en
/
A31008
-
M2257
-
U201
-
5
-
3P19
/
start
i
ng.
f
m
/
17
.
02
.
2012
6
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base sta-
tion. The actual registration procedure will depend on the type of base station.
You must activate manual registration of the handset on both
the handse
t and
the base station.
1. On the base station:
press and hold the registration/paging key for min. 3 sec.
2. On the handset:
within 60 sec. of pres
sing the registration/paging key
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS ¢ OK
¢ Enter the system PIN of the base station (default is 0000) ¢ OK.
Registering flashes in the display.
Registration takes approx. 1 minute.
The following is displayed after succesful
registration:
If more than one handset is registered, the internal
number of the handset is
shown in the upper left cor-
ner.
Initial charging and discharging of the
batteries
The correct charge level can only be displayed if the batteries are first fully charged
and discharged.
Please note
◆ To get the full talk and standby times, 2 to 3 full charge and discharge
cycles are needed.
◆ After the third battery charge and discharge you may replace your handset
in the base station or charging cradle after every call.
◆ Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
◆ The batteries may warm up during charging. This is not dangerous.
◆ After a while, the charge capacity of the batteries will decrease for techni-
cal reasons.
Warning
Please ensure that the handset is in the charging cradle if you are absent for a
long ti
me (e
.g. during holidays) or remove the batteries from the handset. Else
the batteries could be damaged.
1 U
INT MENU
¤ Place the handset in the base station or charging cradle for 18
hours.
¤ Then remove the handset from the base station or charging cra-
dle and do not replace it until the batteries are completely dis-
charged.
18 h