Operation Manual

38
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Configuring other settings with the Web configurator
Maxwell Basic / LUG CA-IE-UK-US-International en / A31088-N4002-R101-4-7619 / web_configurator.fm / 1/10/18
Telephony
Changing the standard send connection
If the telephone has more than one VoIP connection, outgoing calls are initiated via the standard
send connection (
p. 12).
Changing the standard send connection:
¤ Settings Telep hony Connections
All the configured connections are shown. The check box under Def
ault send Connection
shows which connection is currently selected.
¤ Check the connection required Set
Only active connections can be selected.
If the standard send connection selected cannot be accessed, use another connection:
¤ Set the switch next to SIP Accounts-Failover to Ye s
Settings for Call Waiting
Specify the telephone's response when another call comes in during a call.
¤ Settings Telep hony Call Settings
For each connection:
Prevent/permit Call Waiting:
¤ Select the option under Display Waiting Call ( = Call Waiting permitted) /
deselect ( = Call Waiting not permitted)
Permit Call Waiting:
¤ Select Acoustic signal from the list
Off: the incoming call is shown in the display only
or signalling with a Call Waiting tone (beep): once or every 4, 10, or 20 seconds
Save the settings: Set